Pacifica V6-3.8L VIN L (2005)
51.
Disengage J-retainers and flip up the carpet on the seat back and remove the 10 fasteners (Phillips) attaching the load floor to the frame (Fig. 15).
52.
Disengage the black and grey fittings on handle cable from the latch mechanism on each side of the seat (Inboard & Outboard). Load floor
assembly is now free (Fig. 13).
53.
Disassemble the handle from the load floor. Remove the 2 release handle fasteners and pull the cables from the retention points in the load floor.
Remove and discard the release handle/cables.
54.
Position the appropriate new release handle in the seat back. Route and snap the cables into the retention points in the load floor (Fig. 16).
55.
Secure the handle to the load floor with 2 fasteners. Tighten the fasteners to 4 N.m (35 in.lbs.).
56.
Place the load floor and handle assembly on top of the frame and latch assembly. Fasten the load floor to the frame 10 places (Fig. 15).
57.
Snap the black handle cable fittings onto the latch actuation pin on both sides of the seat (Inboard & outboard) (Fig. 13).
58.
Snap the grey cable fittings into the eyelet on the latch on each side of the seat. Verify the fittings are fully engaged and the latches operate as they
should (Fig. 13).
59.
Secure both latch covers to the load floor with 2 plastic anchors on each cover (one in the back and one on the side) (Fig. 11).
60.
Position the foam and trim assembly to the frame of the seat.
61.
Feed the trim flaps around the child seat latch wires so that they are visible. Place the front of the seat back face down. Secure the trim flaps to the
load floor with an anchor (2 places).