Pacifica V6-3.8L VIN L (2005)
62.
Zip the sides of the trim cover closed. Fold over the end of the zipper and tuck it under the trim cover.
63.
On the trim cover side facings fold under the bottom and install the 2 plastic anchors (2 places on each side).
64.
Secure the J-retainers along the bottom of the seat back (3 places) (Fig. 8).
65.
Tuck the carpet flap under the tether wires (2) on the backside of the seat and install the child seat tether bezel shields (2) by placing them over the
tether wires and snapping them into the load floor (Fig. 6).
66.
Install the release handle bezel. Lift the handle up and place the bezel over it. Secure the front of the bezel and then secure the rear snap feature.
67.
Install the head restraint sleeves and head restraint.
68.
Locate the seat back hinge on the seat cushion and start the fastener on each side of the seat. Tighten both fasteners to 25 N.m (221 in.lbs.) (Fig.
5).
69.
Slide the seat back hinge shields onto the seat back hinges. Secure with the color matched plastic anchor.
70.
Install the 4 plastic anchors on the cushion trim cover located on the underside of the cushion (Fig. 1).
71.
Assemble the left seat to the rear floor mounting bracket. Tighten the 2 fasteners to 50 N.m (37 ft.lbs.) (Fig. 3).
72.
Install the 2 fasteners attaching the two front seat legs to floor mounting bracket on the left seat (Fig. 2). Tighten each fastener to 25 N.m (221
in.lbs.).
73.
Install the floor mount bracket shields.
74.
Install the second row bench seat assembly in the vehicle. Refer to the detailed service information available in TechCONNECT, under: Service
Info, 23-Body, Seats, Seat, Installation, Second Row Seat.