Pacifica V6-3.8L VIN L (2005)
7) Remove two brake caliper guide pin bolts (Fig. 6).
8) Remove disc brake caliper from brake adapter and hang out of way using wire or a bungee cord. Use care not to overextend brake hose when
doing this.
9) Remove brake shoes from disc brake caliper adapter (Fig. 7).
10) Install master cylinder fluid reservoir cap.
INSTALLATION
NOTE: Perform Step 1 through Step 6 on each side of vehicle.
1) Place brake shoes in anti-rattle clips on adapter (Fig. 7). Make sure clips are properly installed (Fig. 8).
2) If applied, remove protective paper from noise suppression gasket on rear of both inner and outer brake shoes.
3) Completely retract caliper piston back into bore of caliper.
CAUTION: Use care when installing caliper onto disc brake adapter to avoid damaging boots on caliper guide pins.