Pacifica V6-3.8L VIN L (2005)
5) Position master cylinder on studs of power brake booster (Fig. 13), aligning booster push rod with master cylinder piston.
6) Install two master cylinder mounting nuts (Fig. 13). Tighten both mounting nuts to 25 Nm (225 inch lbs.) torque.
7) Thread primary and secondary brake tubes into ICU ports as shown (Fig. 12). Brake tubes must be held securely when tightened to control
orientation of flex section. Tighten tube nuts to 14 Nm (120 inch lbs.) torque.
8) Connect wiring harness connector to brake fluid level switch mounted in brake fluid reservoir (Fig. 11).
9) Place coolant recovery bottle in its normal mounted position and install nuts fastening it in place.
10) Connect negative battery cable to battery post.
11) Hook up DRBIII(R) to initialize CAB.
12) Fill master cylinder with clean, fresh Mopar Brake Fluid or equivalent, then bleed base brakes and ABS.
13) Road test vehicle to ensure proper operation of brakes.