Pacifica V6-3.8L VIN L (2005)
10) Disconnect four Chassis brake tubes at ABS ICU (Fig. 14). Cap off brake tubes and install sealing plugs in open brake tube outlet ports of ICU.
11) Disconnect 47-way wiring connector at CAB (Fig. 15).
12) Loosen 2 bolts fastening ABS ICU bracket to frame rail (Fig. 15).
13) Lift ICU off frame rail bolts and remove from vehicle.
14) If CAB and HCU need to be separated, Refer to ICU (INTEGRATED CONTROL UNIT) - DISASSEMBLY.
INSTALLATION
1) Place ICU with mounting bracket over two mounting bolts in frame rail (Fig. 15). Tighten bolts to 24 Nm (18 ft. lbs.) torque.
2) Connect 47-way wiring connector at CAB (Fig. 15).
NOTE: When installing chassis brake tubes on ICU, install and tighten two center tube nuts before installing the outer tubes. This action makes it
easier to fit a crowfoot wrench and torque wrench in to tighten center brake tube nuts.
3) Connect four Chassis brake tubes to outlet ports of ICU (Fig. 14). Tighten brake tube nuts to 14 Nm (120 inch lbs.) torque.
CAUTION: When installing master cylinder on vehicle, a NEW vacuum seal MUST be installed on master cylinder.
4) Install NEW vacuum seal on rear of master cylinder making sure seal fits squarely in mounting groove.