Pacifica V6-3.8L VIN L (2005)
Parking Brake Cable: Service and Repair
Front
PARKING BRAKE CABLE FRONT
REMOVAL
1) Disconnect and isolate battery negative cable from battery post.
2) Lock out automatic adjuster in parking brake lever.
3) Raise and support vehicle.
NOTE: It may be necessary to back off parking brake shoe adjustment to allow sufficient slack to disengage cable buttons from connectors in
following two steps.
4) Slide left rear cable button inboard and remove from equalizer (Fig. 70).
5) While holding cable connector on end of front cable secure with a pair of pliers at the front cable button, slide right rear cable button inboard and
remove from cable connector (Fig. 70).
6) Slide equalizer off front cable housing and remove (Fig. 73).
7) Remove cable guide screw securing front parking brake cable to left body rail (Fig. 70).
8) Lower vehicle.
9) Roll vehicle off hoist as necessary to open left side doors.
10) Remove left front and left rear door opening sill scuff plates.
11) Remove left front and left rear door weather strips.
12) Remove lower cowl trim.
13) Remove left front seat belt anchor bolt at B-pillar.
14) Remove left B-pillar trim panel.