Pacifica V6-3.8L VIN L (2005)
7) Rotate the crankshaft until the number 6 piston is at TDC.
8) To ensure correct thrust bearing alignment the following procedure must be done:
a. Move crankshaft all the way to the rear of its travel.
b. Then, move crankshaft all the way to the front of its travel.
c. Wedge an appropriate tool between the rear of the cylinder block and rear crankshaft counterweight. This will hold the crankshaft in it's most
forward position.
d. Tighten the #2 Thrust Bearing cap bolts to 41 Nm + 1/4 Turn (30 ft. lbs.+ 1/4 Turn). Remove the holding tool.
9) Install oil pan.
10) Fill engine crankcase with proper oil to correct level.