Pacifica V6-3.8L VIN L (2005)
Horn Switch: Service and Repair
REMOVAL
WARNING:THIS SYSTEM IS A SENSITIVE, COMPLEX UNIT. DISCONNECT AND ISOLATE THE BATTERY NEGATIVE CABLE
BEFORE BEGINNING AIRBAG SYSTEM COMPONENT REMOVAL OR INSTALLATION PROCEDURES. THIS WILL DISABLE THE
AIRBAG SYSTEM. FAILURE TO DISCONNECT THE BATTERY COULD RESULT IN ACCIDENTAL AIRBAG DEPLOYMENT AND
POSSIBLE PERSONAL INJURY.
ALLOW SYSTEM CAPACITOR TO DISCHARGE FOR TWO MINUTES BEFORE REMOVING AIRBAG COMPONENTS.
DO NOT PLACE AN INTACT UNDEPLOYED AIRBAG FACE DOWN ON A SOLID SURFACE, THE AIRBAG WILL PROPEL INTO
THE AIR IF ACCIDENTALLY DEPLOYED AND COULD RESULT IN PERSONAL INJURY. WHEN CARRYING OR HANDLING AN
UNDEPLOYED AIRBAG, THE TRIM SIDE OF THE AIRBAG SHOULD BE POINTING TOWARDS THE BODY TO MINIMIZE
POSSIBILITY OF INJURY IF ACCIDENTAL DEPLOYMENT OCCURS.
1. Disconnect and isolate the battery negative cable.
2. Remove the driver's side airbag.
3. Remove the airbag trim cover.
4. Disconnect the black wire from the air bag.
Horn Switch
5. Remove only the thin membrane switch from the airbag. Do not remove the hard backer plate from the airbag .
INSTALLATION
1. Install the horn switch to the backer plate.
2. Connect the black wire to the airbag.
3. Install the airbag trim cover.
4. Install the driver's airbag.
5. Connect the battery negative cable.