Pacifica V6-3.8L VIN L (2005)
4.
Position the under car portion of the shield along the inner side of the right frame rail just above the bottom frame radius.
NOTE:
Make sure the shield is not positioned below the frame rail on the inside of the frame.
5.
Mark and center punch the location of the two holes to be drilled in the frame.
6.
Drill two 6.4 mm (0.25 in.) holes in the marked locations.
7.
Apply rust inhibitor, p/n 05093981AA, on the bare metal exposed by drilling the two holes.
8.
Attach the two remaining push pins.
POLICY:
Reimbursable within the provisions of the warranty.
TIME ALLOWANCE:
FAILURE CODE:
Disclaimer:
This bulletin is supplied as technical information only and is not an authorization for repair.