Pacifica V6-3.8L VIN L (2005)
Regulator Ground Removal
9. Remove wire from side of regulator, depressed tab on the connector in order to remove the ground wire.
Ground Removed
10. Ground wire removed.
11. Use a socket to compress the 4 tabs that retain regulator.
12. Pry up regulator and remove regulator and O-rings.
INSTALLATION
NOTE: The O-rings should be placed on the regulator first, to prevent them from being rolled out of position during regulator install.
1. Lightly lubricate the O-rings with clean engine oil and place them onto regulator.
2. Push regulator down and into place.
3. Install ground wire.
4. Install module and gasket seal.
5. Ensure seal is properly positioned in fuel tank groove.