Pacifica V6-3.8L VIN L (2005)
16.
Connect the wires from the passenger side level sensor to the new pump module.
17.
Install the fuel pump module top to fuel tank and then install the fuel pump module lock ring.
NOTE:
Use a brass punch to install the lock ring 1/4 turn.
18.
Connect the vapor line and the electrical connector onto the driver's side fuel module (Figure 5).
19.
Place the fuel tank back onto the transmission jack.
20.
Raise the fuel tank into position and install the fuel tank straps. Tighten the mounting strap bolts to 40 ft. lbs. (54 N.m).
21.
Install the fuel filler tube onto the rubber fuel tank fill hose and tighten the screw clamp securely.
22.
Install the left rear wheel well plastic splash shield.
23.
Install the tire/wheel assembly. Tighten the lug nuts to 100 ft. lbs. (135 N.m) and in the sequence shown in Figure 9.
24.
For vehicles with all wheel drive, place the driveshaft in position with jack stands.
25.
For vehicles with all wheel drive, align the marks made in Step 3j and install the front driveshaft onto the PTU. Install the front driveshaft bolts
and tighten to 22 ft. lbs. (30 N.m).
26.
For vehicles with all wheel drive, install the driveshaft center and rear support/bearing mounts. Tighten the support-to-body bolts to 40 ft. lbs. (54
N.m).
27.
For vehicles with all wheel drive, align the marks made in Step 3j and install the driveshaft onto the rear axle. Then tighten the bolts to 40 ft.lbs
(54 N.m).
28.
Connect the fuel line, EVAP line and vapor recirculation tube located at the right front corner of the fuel tank (Figure 4).
29.
Connect the fuel tank electrical connector located at the rear of the tank (Figure 3).
30.
With the help of an assistant, place the rear portion of the exhaust system into position and support the exhaust system with jack stands.
31.
Connect the inlet pipe of the front muffler to the outlet pipe of the catalytic converter. Tighten the exhaust pipe clamp to 40 ft. lbs. (54 N.m)
32.
Install the center exhaust hanger rubber grommets.
