Pacifica V6-3.8L VIN L (2005)
7.
Use the table to determine your course of action:
MEMORY HEATED SEAT ADJUSTABLE PEDAL MODULE REPLACEMENT
PROCEDURE:
1.
Disconnect and isolate the negative battery cable.
NOTE:
Module replacement does not always require seat removal. If seat is adjusted too low and access to module is hindered, seat removal is
recommended. If module can be accessed and SEAT TRACK GROUNDING is not required, seat does not need to be removed. Proceed to Step 8
below.
2.
Raise and support vehicle.
3.
If necessary, remove vapor canister to gain access to the seat anchor nuts. Refer to the detailed service information available in TechCONNECT,
under: Service Info, 25 - EMISSIONS CONTROL> EVAPORATIVE EMISSIONS > VAPOR CANISTER> REMOVAL.
4.
Remove four nuts attaching the seat to the floor pan.
5.
Lower the vehicle to access the seat.