Pacifica V6-3.8L VIN L (2005)
6.
Remove the headrest from seat.
7.
Pull the seat rearward and tip the seat so that the top of the seat is resting on the steering wheel. This will allow access to the bottom of the seat.
8.
Disconnect the module wire connectors.
9.
Remove the memory heated seat adjustable pedal module attaching screws.
10.
Remove the module from under drivers seat.
11.
Position the appropriate new Memory Heated Seat Adjustable Pedal Module under the drivers seat and fasten it to the seat.
12.
Connect the electrical connectors to the module.
13.
Inspect for upper seat track ground. Refer to (Fig 9), callout # 2 and # 3 for location of ground connection. Is ground wire connection present on
upper seat track?
a.
Yes >>> proceed to Step # 13 SEAT TRACK GROUNDING REPAIR PROCEDURE below.
b.
No >>> proceed to Step # 8 SEAT TRACK GROUNDING REPAIR PROCEDURE below.
SEAT TRACK GROUNDING REPAIR PROCEDURE:
NOTE:
Seat must be removed to perform this procedure.
1.
Raise and support vehicle.
2.
Disconnect and isolate the negative battery cable.
3.
If necessary, remove vapor canister to gain access to the seat anchor nuts. Refer to the detailed service information available in TechCONNECT,
under: Service Info, 25 - EMISSIONS CONTROL> EVAPORATIVE EMISSIONS > VAPOR CANISTER > REMOVAL.
4.
Remove four nuts attaching the seat to the floor pan.
5.
Lower the vehicle to access the seat.
6.
Remove the headrest from seat.
7.
Lift and tip the seat forward, (Fig 7), to access wire connector under seat and disconnect wire connectors. Pull the seat rearward and tip the seat so
that the top of the seat is resting on the steering wheel. This will allow access to the bottom of the seat.
8.
Locate the existing hole on the inboard side of the upper seat track. Fasten the ground eyelet to the seat track side member using the screw and nut
provided in kit, p/n 05183713AA. Position the bolt on the outboard side of the rail and the nut on the inboard side of the rail. Tighten the nut to 10
N.m (88 in. lbs.) (Fig 9).