Pacifica V6-3.8L VIN L (2005)
Internal Pump Connector O-Ring
3. Replace pump/motor connector O-ring if not new.
4. With connector cover completely open, install 47-way wiring connector into socket of the ABM and close cover, locking connector in place.
5. Align ABM solenoids and pump/motor wiring connector with HCU valves and connector passage. Slide ABM onto HCU.
6. If not equipped with traction control, install three screws attaching the ABM to the HCU. Tighten mounting screws to 2 N.m (17 in. lbs.) torque.
7. If equipped with traction control, install four screws attaching ABM to HCU. Tighten mounting screws to 2 N.m (17 in. lbs.) torque.
8. Lower vehicle.
9. Connect negative battery cable to battery post.
10. Hook up scan tool to initialize ABM. Check and clear any faults.