Pacifica V6-3.8L VIN L (2005)
Seat Belt & Retractor - 3rd Row - Remove/Install
4. Remove second and third row lower seat belt anchor bolt covers and lower seat belt anchor bolts from the lower quarter trim panel at the C and
D-pillars.
5. Remove lower quarter trim panel.
6. Remove the two seat belt retractor mounting bolts.
7. Remove the turning loop cover and retaining bolt from the upper quarter panel.
8. Remove seat belt and retractor from vehicle.
INSTALLATION
1. Position seat belt and retractor in vehicle.
2. Install the turning loop retaining bolt into the C-pillar. Torque bolt to 40 N.m (30 ft. lbs.) and install seat belt turning loop cover.
3. Install the two seat belt retractor mounting bolts. Torque bolts to 40 N.m (30 ft. lbs.).
4. Install the lower quarter trim panel.
5. Install the second and third row lower seat belt anchor bolts. Torque bolts to 40 N.m (30 ft. lbs.) and then install lower anchor bolt covers.
6. Install the second and third row seats into vehicle on the side that the seat belt and retractor are being serviced.
7. Connect the battery negative cable.
8. Verify vehicle and system operation.
9. Close hood.