Pacifica V6-3.8L VIN L (2005)
Seat Belt Height Adjuster: Service and Repair
Seat Belt Height Adjuster
REMOVAL
1. Gently pull inward on height adjuster knob cover on the side of the vehicle that you wish to remove the height adjuster.
2. Remove upper B-pillar trim.
3. Remove turning loop to height adjuster retaining bolt.
Seat Belt Height Adjuster - Remove/Install
4. Remove two mounting bolts to height adjuster and remove from vehicle.
INSTALLATION
1. Position height adjuster in place and install the two mounting bolts.
2. Install the turning loop to height adjuster retaining bolt. Torque bolt to 40 N.m (30 ft. lbs.).
3. Install the upper B-pillar trim.
4. Position the height adjuster knob cover onto the height adjuster knob and firmly snap into place.
5. Verify system operation.