Pacifica V6-3.8L VIN L (2005)
3. Place Installer, Special Tool 6758, over top of seal boot and squarely align it with bottom edge of seal boot (Fig. 16). Apply hand pressure (or
gently tap with a hammer if necessary) to top of Installer until seal boot is pressed squarely down against top surface of lower control arm.
4. Wipe any grease off ball joint stem using a clean shop towel with Mopar Brake Parts Cleaner applied to it.
CAUTION: Do not attempt to install a normal grease zirc in ball joint in an effort to lubricate joint through zirc fitting.
5. Install steering knuckle on vehicle.