chrysler Workshop Repair Guides

Chrysler Workshop Service and Repair Manuals

Suspension - Low Speed Rattle/Clunk Noise|Page 5380 > < Lower Ball Joint|Page 5371
Page 1
background image

Control Arm: Customer Interest
Suspension - Low Speed Rattle/Clunk Noise

NUMBER: 02-007-04

GROUP: Suspension

DATE: October 18, 2004

THIS BULLETIN IS BEING PROVIDED IN ADVANCE. DO NOT ORDER PARTS OR PERFORM ANY ACTIONS RELATED TO THIS
BULLETIN UNTIL OCTOBER 25, 2004.

SUBJECT:
Low Speed Rattle/Clunk Sound From Front Suspension

OVERVIEW:
This bulletin involves replacing the front suspension lower control arms.

MODELS:

2004 - 2005

(CS)

Pacifica

NOTE:

This bulletin applies to vehicles built on or before September 28, 2004 (MDH 0928XX).

SYMPTOM/CONDITION:

The vehicle operator may describe a rattle/clunk sound which may be heard from the front suspension while driving between 16 - 40 km/h (10 - 25 mph),
over minor bumps/road fluctuations. The rattle/clunk sound is caused by the lower control arm rear bushing.

DIAGNOSIS:

Road test the vehicle at low speeds, 16 - 40 km/h (10 - 25 mph), driving over minor bumps and listening for the rattle/clunk sound from the front 
suspension. A road test driving 8 - 16 km/h (5 - 10 mph) in a parking lot and briefly applying the brakes on/off to load the front suspension lower control
arms may duplicate the sound. The technician may also use chassis ears on the lower control arms near the rear bushing, to aid in diagnosis.

If the technician experiences the Symptom/Condition, perform the Repair Procedure.

PARTS REQUIRED:

SPECIAL TOOLS/EQUIPMENT REQUIRED:

REPAIR PROCEDURE:

1.

Replace both front lower control arm assemblies. Refer to the service information available on TechCONNECT. Refer to 2 - Suspension
/Front/Lower Control Arm - Removal.

POLICY:
Reimbursable within the provisions of the warranty.

Suspension - Low Speed Rattle/Clunk Noise|Page 5380 > < Lower Ball Joint|Page 5371