Pacifica V6-3.8L VIN L (2005)
i.
Remove special tools.
j.
Install end of parking brake cable into mounting hole in crossmember. Slide cable retainer on end of cable housing into hole until retainer
fingers click into place.
4. Install stabilizer bar with cushions and retainers on crossmember.
Fig. 75
5. Install cushion retainer mounting bolts (Fig. 75). Do not tighten at this time.
6. Install bolt and nut fastening stabilizer bar to each stabilizer link (Fig. 75). Do not tighten at this time.
7. Tighten cushion retainer mounting bolts to 61 N.m (45 ft.lbs.) torque.
8. Raise crossmember to body mounting points. As crossmember is raised, align shocks with pockets in spring links.
Fig. 76
9. Continue to raise crossmember with jack until crossmember mounting bolts can be installed. Install left side crossmember mounting bolts, but not
the right side bolts (Fig. 76). It is not necessary to tighten bolts at this point.