Pacifica V6-3.8L VIN L (2005)
CAUTION: To avoid damaging other components of vehicle, do not lower crossmember any further than necessary to install coil spring.
10. Slowly lower jack allowing right side of crossmember to drop. Do not lower jack at a fast rate. Lower jack just enough to allow spring installation.
Do not lower jack any further than necessary.
Fig. 77
11. Install coil spring and isolator (Fig. 77), top end first.
NOTE: Verify that spring lower end coil is correctly placed against abutment built into spring link.
12. Carefully raise jack, guiding coil spring and lower end of shock absorber into mounted positions. Once shock absorber lower mounting hole lines
up with hole in spring link, stop jacking.
Fig. 78
13. Install lower shock mounting bolt (Fig. 78). Do not tighten at this time.
14. Raise right side of crossmember into mounted position. Install right side crossmember mounting bolts (Fig. 76). Do not fully tighten bolts at this