Pacifica V6-3.8L VIN L (2005)
time.
15. Remove both front and rear crossmember mounting bolts on left side of vehicle (Fig. 76).
CAUTION: To avoid damaging other components of vehicle, do not lower crossmember any further than necessary to install coil spring.
16. Slowly lower jack allowing left side of crossmember to drop. Do not lower jack at a fast rate.Lower jack just enough to allow spring installation.
Do not lower jack any further than necessary.
17. Install coil spring and isolator (Fig. 77), top end first.
NOTE: Verify that spring lower end coil is correctly placed against abutment built into spring link.
18. Carefully raise jack, guiding coil spring and lower end of shock absorber into mounted positions. Once shock absorber lower mounting hole lines
up with hole in spring link, stop jacking.
19. Install lower shock mounting bolt (Fig. 78). Do not tighten at this time.
20. Raise left side of crossmember into mounted position and install previously removed mounting bolts (Fig. 76). Do not fully tighten bolts at this
time.
Fig. 79
21. Shift crossmember as necessary to line up mounts with location marks drawn in before removal (Fig. 79).