Pacifica V6-3.8L VIN L (2005)
6. Remove shock absorber lower mounting bolt and nut (Fig. 33).
CAUTION: When removing crossmember mounting bolts it is important NOT to loosen or remove crossmember mounting bolts on opposite side
of vehicle. Doing so will require rear wheel alignment following reinstallation to ensure proper thrust angle.
7. Remove both front and rear crossmember mounting bolts on repair-side of vehicle (Fig. 35).
CAUTION: To avoid damaging other components of vehicle, do not lower crossmember any further than necessary to remove shock absorber or
coil spring.
8. Slowly lower jack allowing repair-side of crossmember to drop. Do not lower jack at a fast rate. Lower jack just enough to allow top of shock
absorber to clear body flange.