Pacifica V6-3.8L VIN L (2005)
8. Insert special tool #9093 between belt molding and glass at rear and then slide tool forward approximately 14 cm (5.5 in.) (Fig. 5) and (Fig. 6).
9. Push down on outer belt molding and rotate upper part of tool outward from vehicle approximately 6 - 8 cm (2.5 - 3 in.) then lift up on molding
to disengage from locking tab.
10. Repeat step 3 and 4 at as necessary till outer belt molding is free.
11. Remove outer belt molding weatherstrip.
INSTALLATION
1. Place outer belt molding weatherstrip into position (Fig. 5).
2. Press down or tap lightly on outer belt molding until fully seated.
3. Install screw attaching outer belt molding, one at the inside of the front door shut face at the B-pillar.
4. Install side view mirror.
5. Install foam stuffer in mirror flag area.
6. Install frame closeout molding.
7. Install front inner molding weatherstrip.
8. Install door trim panel.
9. Close window.