Pacifica V6-3.8L VIN L (2005)
7. Repeat step 3 and 4 at as necessary till outer belt molding is free.
8. Remove outer belt molding weatherstrip.
INSTALLATION
1. Place outer belt molding weatherstrip into position (Fig. 13).
2. Press down or tap lightly on outer belt molding until fully seated.
3. Install screws attaching outer belt molding, one at the inside of the rear door shut face at the B-pillar and one at the inside of the rear door shut
face at the C-pillar.
4. Install fixed glass run channel.
5. Install rear inner molding weatherstrip.
6. Install door trim panel.
7. Close window.