Pacifica V6-3.8L VIN L (2005)
Windshield Washer Reservoir: Service and Repair
Washer Reservoir Replacement
REMOVAL
1. Disconnect and isolate the battery negative cable.
2. Hoist vehicle.
3. Remove screws at the left wheel opening splash shield.
4. Remove the lower fascia push pins.
5. Remove upper bolts at ends (ears).
6. Disengage lower fascia to grille clips.
7. Pull away fascia as necessary to access reservoir.
8. Disconnect the hoses and electrical connectors from the reservoir.
Filler Tube And Washer Reservoir - Remove/Install
9. Remove three retaining bolts.
10. Pull reservoir from filler tube.
11. Transfer pumps. Make sure to use a new grommet.
12. Transfer sensor. Make sure to use a new grommet.
13. Drain fluid into new reservoir.
INSTALLATION
1. Drain fluid into new reservoir.
2. Transfer sensor. Make sure to use a new grommet.
3. Transfer pumps. Make sure to use a new grommet.
4. Slip reservoir onto filler tube.
5. Install the three reservoir mounting bolts.
6. Connect the hoses and electrical connectors to the reservoir.
7. Engage lower fascia to grille clips.
8. Install the upper bolts at ends (ears).
9. Install the lower fascia push pins.
10. Install the screws at the left wheel opening splash shield.
11. Remove vehicle off of hoist.
12. Connect the battery negative cable.
13. Verify vehicle and system operation.
14. Top off washer fluid.
15. Close hood.