PT Cruiser L4-2.4L (2008)
Upper Side Moulding / Trim: Service and Repair
Molding-Deck Upper Belt - Convertible
Removal - Convertible
REMOVAL - CONVERTIBLE
1. Adjust the convertible top open/close to access the four screws (1) that secure the deck upper belt molding (3).
2. Remove the four screws that secure the deck upper belt molding to the quarter panels (2) and remove the molding.
Installation - Convertible
INSTALLATION - CONVERTIBLE
1. Adjust the convertible top open/close to access the four screws (1) that secure the deck upper belt molding.
2. Position the deck upper belt molding (3) to the quarter panels (2). Make sure to center the molding to the rear of the vehicle.
3. Install the four screws that secure the deck upper belt molding. Tighten the screws to 2.2 Nm (20 in. lbs.).
4. Raise the convertible top.