PT Cruiser L4-2.4L (2008)
6. Remove the retaining clip (4) securing the power brake booster push rod to the brake pedal. To do so, position a small screwdriver (1) under the
center tang of the retaining clip, then rotate the screwdriver enough to allow the retaining clip tang to pass over the end of the brake pedal pin (3).
Remove and discard the clip. Do not reuse the clip.
7. Slide the booster push rod (2) off the brake pedal pin (3).
8. Remove the pedal pivot shaft (4) nut.
9. Start to remove the pivot shaft (4) out the left side of the bracket. Pull the shaft to the left until the brake pedal (2) can be removed, stopping short
of removing the shaft from the clutch pedal.
10. Slide the brake pedal (2) out of its bracket and remove it from the vehicle.
11. If necessary, remove the bushings (1) from the pedal by sliding them out each side of the pivot.
