PT Cruiser L4-2.4L (2008)
11. Mount and adjust the NEW stop lamp switch using the following procedure:
a. Insert the plunger end of the switch in the mounting bracket by aligning the index tab on the switch with the slot in the mounting bracket.
b. When the switch is fully seated in the bracket, rotate the switch clockwise approximately 30° to lock the switch into place.
c. With the brake pedal in the fully released position, move the lever on the back of the stop lamp switch from the non-adjusted angle position to
the full vertical position. This will permanently adjust the switch to the vehicle.
12. Install the knee blocker.
13. Install the silencer pad below the knee blocker.
14. Connect the battery negative cable (1) to its post on the battery (4).