PT Cruiser L4-2.4L (2008)
4. Hand start the brake tube (3) nut to the wheel cylinder (1). Tighten the tube nut to 17 Nm (145 in. lbs.).
5. Lubricate shoe contact areas on support plate and anchor using Mopar(R) Brake Lubricant or equivalent.
NOTE: Inspect the brake shoes before installation. See: Disc Brake System/Brake Pad/Service and Repair/Procedures/Brake Pads - Inspection
6. Install the pre-assembled brake shoe assembly over the wheel cylinder (2) and the anchor (3) on the brake support plate.
