PT Cruiser L4-2.4L (2008)
5. Using a Brake Shoe Gauge (1), Special Tool C-3919 or equivalent, measure the inside diameter of the brake drum at the center of the shoe contact
area. Tighten the Gauge set-screw at this measurement.
6. Place the other side of the brake shoe gauge (1) over the brake shoes as shown.
7. Adjust the shoe diameter to the setting on the gauge. To adjust the shoe diameter, turn the adjuster-screw star-wheel using a screwdriver inserted
through the adjusting hole in the rear of the shoe support plate. Once the tip of the screwdriver contacts the star-wheel teeth, move the handle of
tool downward using the support plate as a pivot to adjust the shoes outward.
8. Once the shoe diameter is set, remove the tool and install the brake drum (6). See: Brake Drum/Service and Repair/Removal and
Replacement/Installation
9. Turn the brake drum. A slight drag should be felt while rotating the drum. If not, repeat the above procedure.
