PT Cruiser L4-2.4L (2008)
CAUTION: When installing a master cylinder on the vehicle, a NEW vacuum seal (2) MUST be installed on the master cylinder mounting
flange (1).
3. If the master cylinder does not have a new vacuum seal (2) installed on the mounting flange (1), remove it. Install a NEW vacuum seal on the
master cylinder mounting flange making sure the seal fits squarely in its groove.
CAUTION: If resistance is met during master cylinder insertion into power brake booster, the master cylinder push rod may not be lined
up with the booster push rod. Remove the master cylinder, realign and insert it again.
4. Line the master cylinder mounting holes up with the mounting studs on the power brake booster. Ensure the master cylinder piston push rod lines
up with the booster push rod, then carefully slide the master cylinder into the power brake booster until it contacts the face of the booster.
5. Install the two master cylinder mounting nuts (3). Tighten each nut to 25 Nm (221 in. lbs.).
6. If equipped with a manual transaxle and a new reservoir is being installed, using an appropriate cutting tool, cut the clutch actuator port at the
center of the "V" groove (1) opening the hydraulic clutch port (3). Discard the severed plug (2).
