PT Cruiser L4-2.4L (2008)
7. If equipped with a manual transaxle, slide the clutch actuator hose (1) onto the reservoir port. Install the hose clamp (2) just past the upset bead (3)
on the port.
8. Connect the primary (5) and secondary (4) brake tubes to the master cylinder outlet ports. Tighten tube nuts to 17 Nm (145 in. lbs.).
9. Connect the brake fluid level switch wiring connector (2) to the switch.
10. Install the power distribution center.
11. Connect the negative (ground) cable on the battery.
12. Install the air cleaner housing.
13. Reinstall the air cleaner cover.
14. Fill the master cylinder reservoir to the proper level. See: Brake Fluid/Service and Repair
WARNING: Be certain a firm brake pedal is achieved prior to attempting to operate the vehicle. If a firm brake pedal cannot be
achieved, bleed the brake hydraulic system and check for leaks. See: Brake Bleeding
