PT Cruiser L4-2.4L (2008)
6. Turn crankshaft until number 1 cylinder is at top dead center (TDC). The timing marks on the chain sprocket (1) should line up with the parting
line (5) on the left side of number one main bearing cap.
7. Place chain over crankshaft sprocket so that the plated link of the chain is over the number 1 cylinder timing mark on the balance shaft crankshaft
sprocket.
8. Place balance shaft sprocket into the timing chain and align the timing mark on the sprocket (dot) with the (lower) plated link on the chain.
NOTE: The lower plated link(4) is 8 links from the upper link (6).
9. With balance shaft keyways pointing up (2) (12 o'clock) slide the balance shaft sprocket onto the nose of the balance shaft. The balance shaft may
have to be pushed in slightly to allow for clearance.
