PT Cruiser L4-2.4L (2008)
Impact Sensor: Service and Repair
Sensor-Satellite Acceleration - PT27
Removal
REMOVAL
1. Open hood.
2. Disconnect and isolate the battery negative cable.
WARNING: Wait two minutes for the airbag system reserve capacitor to discharge before beginning any airbag system or component
service. Failure to do so may result in accidental airbag deployment, serious or fatal injury.
3. Remove the lower quarter trim from the appropriate side of the vehicle.
4. Disconnect the Satellite Acceleration Sensor (SAS) electrical connector (2).
5. Remove the SAS retaining screws (1) and remove the sensor (5) from the vehicle (3).
Installation
INSTALLATION
1. Position the Satellite Acceleration Sensor (SAS) (5) in position.
2. Install the retaining screws (1). Tighten the screws to 10.5 Nm (95 in. lbs.).
3. Connect the SAS electrical connector (2).
4. Install the quarter panel trim.
WARNING: Do not connect the battery negative cable. Serious or fatal l injury may result if the system test is not performed first.
