PT Cruiser L4-2.4L (2008)
properly.
12. Slide the ring of the SKREEM/WCM (2) over the lock cylinder housing (3) and engage the retainer fingers in the recesses formed on the lock
cylinder housing.
13. Install the screw (1) fastening the SKREEM/WCM (2) to the lock cylinder housing (3). Tighten the screw to 3.5 Nm (31 in. lbs.).
14. If the vehicle is equipped with an automatic transaxle, connect the ignition shift interlock cable to the steering column by inserting the cable
connector (3) into the lock cylinder housing until it snaps into place. Make sure the connector is locked in place.
15. Install the column wiring harness routing clip on the bottom of the lock cylinder housing.