PT Cruiser L4-2.4L (2008)
Alignment: Service and Repair
Curb Height Measurement
CURB HEIGHT MEASUREMENT
NOTE: This vehicle uses the Fender Curb Height method for measuring curb height. Curb height is measured from the inboard edge of the
wheel opening lip on the fender (directly above wheel center), down to ground level.
The wheel alignment is to be checked and all alignment adjustments made with the vehicle at its required curb height specification.
Vehicle height is to be checked with the vehicle on a flat, level surface, preferably a vehicle alignment rack. The tires are to be inflated to the
recommended pressure. All tires are to be the same size as standard equipment. Vehicle height is checked with the fuel tank full of fuel, and no passenger
or luggage compartment load.
Vehicle height is not adjustable. If the measurement is not within specifications, inspect the vehicle for bent or weak suspension components. Compare
the parts tag on the suspect coil spring(s) to the parts book and the vehicle sales code, checking for a match. Once removed from the vehicle, compare
the coil spring height to a correct new or known good coil spring. The heights should vary if the suspect spring is weak.
NOTE: Prior to reading the curb height measurement, the front and rear of the vehicle must be jounced to settle the suspension. Induce jounce
by pushing down on the center of the bumper (fascia), using care not to damage the vehicle, moving the vehicle up and down, gradually
increasing the suspension travel with each stroke. Release the bumper at the bottom of each stroke, repeating this action several times. Perform
this to both front and rear suspensions an equal amount of times.
Measure curb height at each wheel opening as follows:
1. Jounce the vehicle. Refer to above note.
2. Measure (1) from the bottom inboard edge of the wheel opening fender lip directly above the wheel center (spindle) down to the floor (ground) or
alignment rack surface.
3. When measuring, maximum left-to-right differential is not to exceed 10 mm (0.39 in.).
4. Compare the measurements to specifications listed in the following CURB HEIGHT SPECIFICATIONS chart.
