PT Cruiser L4-2.4L (2008)
7. Position the knuckle with the wheel bearing installed back in the arbor press with the smaller end of Remover/Installer (3), Special Tool
MB-990799, supporting the inner race of the wheel bearing as shown.
8. Place the wheel hub (2) in the wheel bearing making sure it is square with the bearing inner race. Lower the arbor press ram (1) and press the hub
into the wheel bearing until it is fully bottomed in the wheel bearing.
9. Remove the knuckle the press and verify the hub turns smoothly without rubbing or binding.
10. Install the knuckle on the vehicle. See: Front Steering Knuckle - Installation
