PT Cruiser L4-2.4L Turbo VIN 8 (2005)
DIAGNOSIS:
Using a Scan Tool (DRBIII(R)) with the appropriate diagnostic procedures on TechCONNECT, verify all engine systems are functioning as designed. If
DTCs are present, other than the one listed above, record them on the repair order and repair as necessary before proceeding further with this bulletin.
If the customer describes the Symptom/Condition perform the Repair Procedure.
PARTS REQUIRED:
SPECIAL TOOLS/EQUIPMENT REQUIRED:
NOTE:
An updated J1962 cable has been released. This cable has a red colored connector at the DRBIII(R) connection. Use this cable whenever a flash is
being performed.
REPAIR PROCEDURE:
NOTE:
Whenever a controller is programmed, the software in the DRBIII(R); must be programmed with the latest revision level available.
NOTE:
If this flash process is interrupted/aborted, the flash should be restarted and then follow the directions on the DRBIII(R).
1.
Before beginning the reprogramming procedure, remove any old flash reprogramming files from the DRBIII(R) memory. To clear the memory
from the MAIN MENU:
a.
Simultaneously press the "MORE" and "YES" keys.
b.
A screen will appear requesting a "COLD BOOT".
c.
Follow the on screen instructions by selecting the "F4" key.
d.
When the DRB III(R) reboots to the MAIN MENU, proceed to Step # 2
2.
With the ignition switch in the "RUN" position, determine the original part number of the PCM currently in the vehicle. Using the DRBIII(R)
select:
a.
"DRBIII(R) Standalone"
b.
"1998 - 2004 Diagnostics"
c.
"All (Except Below)"
d.
"Engine"
e.
"Module Display"
f.
Record the "PCM part # " on the repair order for later reference.
