PT Cruiser L4-2.4L Turbo VIN 8 (2005)
to gain secured access to the SKIM for service. The SKIM also stores in its memory the Vehicle Identification Number (VIN), which it learns through
a bus message from the PCM during initialization. The SKIS scrambles the information that is communicated between its components in order to
reduce the possibility of unauthorized SKIM access and/or disabling.
When the ignition switch is moved to the RUN position, the SKIM transmits an RF signal to the transponder in the ignition key. The SKIM then waits
for a response RF signal from the transponder in the key. If the response received identifies the key as valid, the SKIM sends a "valid key" message to
the PCM over the PCI bus. If the response received identifies the key as invalid or no response is received from the transponder in the ignition key the
SKIM sends an "invalid key" message to the PCM. The PCM will enable or disable engine operation based upon the status of the SKIM messages. It
is important to note that the default condition in the PCM is "invalid key" Therefore, if no response is received by the PCM, the engine will be
immobilized after two (2) seconds of running.
The SKIM also sends indicator light status messages to the instrument cluster to tell that module how to operate the light. This may consist of turning
the light ON for a three (3) second bulb test when the ignition switch is first turned to the ON position. It is also the method used to turn the light ON
solid or to flash it after the indicator light test is complete to signify a fault in the SKIS. If the light comes ON and stays ON solid after the indicator
light test, this signifies that the SKIM has detected a system malfunction and/or that the SKIS has become inoperative. If the SKIM detects an invalid
key OR a key-related fault exists, the indicator light will flash following the indicator light test. The SKIM may also request an audible chime if the
customer key programming feature is available and the procedure is being utilized. Refer to Electrical, Vehicle Theft Security, Transponder Key,
Standard Procedure - Sentry Key Immobilizer System Transponder programming.
