PT Cruiser L4-2.4L Turbo VIN G (2004)
11. Locate the brake pedal-to-power brake booster input rod attachment under the instrument panel. Position a small screwdriver under the center tang
of the retaining clip. Rotate the screwdriver enough to allow the retaining clip tang to pass over the end of the brake pedal pin. Remove the clip.
CAUTION: Discard the used retaining clip, it is not to be reused. Replace the clip with a new one on reassembly.
12. Remove the four nuts attaching the power brake booster to the instrument panel. The nuts are accessible from under the instrument panel in the
area of the brake pedal bracket.
13. Slide the power brake booster forward until mounting studs clear the instrument panel, then remove it from the vehicle.
INSTALLATION- LHD
NOTE: Before power brake booster installation, be certain dash seal is installed on booster mounting studs.
1. Install the power brake booster by sliding the input rod and studs through the dash panel and into mounting position.