Sebring V6-2.5L VIN N (1997)
5. Clean piston and insert into cylinder (caliper) with special tool.
6. Be careful that the piston boot does not catch and tear as the caliper assembly and lock pin are installed.
7. Check brake drag torque as follows.
a. Start engine and hold brake pedal down with a pressure of 196 N (44 lbs.) for 5 seconds.
b. Stop engine.
c. Turn brake disc forward 10 times.
d. Check hub torque to obtain value (B) with spring scale.
e. Calculate the drag torque of the disc brake by calculating the difference between hub torque (B) and hub torque (A).
-
Should be equal to or less than: 69 N (15.4 lbs.) [4 Nm (35 inch lbs.)]
8. If the difference between brake drag torque and hub torque exceeds standard value, disassemble piston and clean the piston. Check for corrosion
or worn piston seal, and check the sliding condition of the lock pin and guide pin.
INSTALLATION
1. Follow procedure in the first image in reverse order.
2. Fill the master cylinder with brake fluid.
3. Bleed the brake system. See: Brake Bleeding
Rear