Sebring V6-2.5L VIN N (1997)
standard value is 0.7 - 1.4 Nm (6 - 12 inch lbs.).
CAUTION:
-
When adjusting, set the standard value at its highest value.
-
Assure no ratcheting or catching when operating rack towards the shaft direction.
NOTE: When it cannot be adjusted within the specified return angle, check rack support cover components or replace.
23. After adjusting, lock rack support cover with lock nut.
24. After installing tie-rod to rack, fold tab washer end (2 locations) to tie rod notch.
25. Touch pliers against the concave section of the bellows band and tighten the bellows band.
26. Use a plastic hammer or similar to bend the convex section of the bellows band as shown.
27. Screw in tie rod end to have the shown dimension. Lock with lock nut.
