Sebring V6-2.5L VIN N (1997)
5. While using the rod to widen the inner cover from behind, pull the cover to remove it from the joint.
6. If it is necessary to remove the steering lock cylinder, use a hacksaw to cut the special bolts at the steering lock bracket side.
INSPECTION
-
Check the steering shaft for play and round movement.
-
Check the joints for play, damage, or rough movement.
-
Check the joint bearing for wear and damage.
-
Check the dust shield for damage.
REASSEMBLY
Follow removal steps in reverse order for installation, noting the following.
1. When installing the steering lock and steering lock bracket to the column tube, temporarily install the steering lock in alignment with the
column boss.
2. After checking that the lock works properly, tighten the special bolts until the head twists off.
CAUTION: The steering lock bracket and bolts must be replaced with new ones when the steering lock is installed.
3. Cover the inside lip of the inner cover with grease and pull the outside of the cover onto the joint.