Sebring V6-2.5L VIN N (1997)
-
Do not apply the vehicle weight to the wheel bearing while loosening the drive shaft nut. If, however, the vehicle weight must be applied to the
bearing (in order to move the vehicle), temporarily secure the wheel bearing by using the special tool, MB990998, etc.
-
Be sure to tie the cord of the special tool to a nearby part.
-
Loosen the nut but do not remove it.
1. If the inner shaft and transaxle are tightly joined, tap the center bearing bracket lightly with a plastic hammer, etc. to remove the drive shaft and
inner shaft (R.H.) from the transaxle.
2. Insert a pry bar between the transaxle case and the drive shaft, and then pry the drive shaft from the transaxle.
CAUTION:
-
Always use a pry bar to remove the drive shaft, or the T.J. will be damaged.
-
Do not insert the pry bar so deep, or the oil seal will be damaged.