Sebring V6-2.5L VIN N (1997)
3. Use the special tool as a cover not to let foreign objects get into the transaxle case.
INSPECTION
-
Check the drive shaft boot for damage or deterioration.
-
Check the ball joints for wear or operating condition.
-
Check the spline part for wear or damage.
INSTALLATION
Follow removal steps in reverse order noting the following.
1. Be sure to install the drive shaft washer as shown.
2. Use the special tool to tighten the drive shaft nut.
CAUTION: Before securely tightening the drive shaft nuts, make sure there is no load on the wheel bearings.
3. If the position of the cotter pin holes does not match, tighten the nut up to 255 Nm (188 ft. lbs.) maximum.
4. Install the cotter pin in the first matching holes and bend it securely.