Sebring Convertible V6-2.5L VIN H (1997)
6. Separate the trailing link from the hanger bracket. To separate trailing link from hanger bracket, use a large adjustable wrench on flat of trailing
link to turn link while holding nut stationary.
CAUTION: The inner and outer trailing link to hanger bracket bushings and retainers must be installed in their correct position on the trailing link.
Do not reverse the position of the inner and outer trailing link bushing or retainers on the trailing link.
NOTE: When installing trailing link into hanger bracket, the flat on the trailing link must be positioned at the hanger bracket.
INSTALL
1. Install the inner bushing retainer, and inner bushing on the trailing link. Install the trailing link, retainer and bushing on the hanger bracket. Then
install the outer bushing, outer bushing retainer and nut on the trailing link. Tighten the trailing link retaining nut to a torque of 99 Nm (73 ft. lbs.).
2. Install knuckle end of trailing link assembly in rear knuckle.
CAUTION: It is important that the following procedure be done when installing the trailing arm hanger bracket to the body of the vehicle. This
procedure will ensure that the hanger bracket is installed in the correct position on the vehicle.
