Sebring Convertible V6-2.7L Flex Fuel (2008)
1. Open decklid in the rear tilt or service position See: Service and Repair/Procedures/Decklid Service Position.
2. Remove the trunk side trim See: Interior Moulding / Trim/Trim Panel/Service and Repair/Trunk Trim Panel - Removal.
3. Mark the existing wedge assembly outline onto the quarter panel to assist in alignment of the new/reassembled wedge assembly.
4. Remove the one nut to the deckbar front wedge assembly which is located just rearward of (1) on the left side of the graphic.
5. Separate the wedge assembly from the quarter panel.
Installation
INSTALLATION
1. Position the wedge assembly on the quarter panel on the inner quarter panel. Use the marks that were scribed prior to the removal.
2. Install the one nut to the deckbar front wedge assembly which is located just rearward of (1) on the left side of the graphic.
3. Install the trunk side trim See: Interior Moulding / Trim/Trim Panel/Service and Repair/Trunk Trim Panel - Installation.
4. Close the decklid. If in the service position See: Service and Repair/Procedures/Decklid Service Position.