Sebring Convertible V6-2.7L Flex Fuel (2008)
13. With the presenter plate assembly (5) on the workbench, disconnect the folding top header latch switch electrical connector (1).
14. Using an 1/8 in. drill bit, drill out the rivet (2) securing the switch (3) to the presenter plate (5).
15. Remove the switch from the presenter plate. Pivot the switch (3) away from the presenter plate to disengage the mounting tab from the slot in the
presenter plate (4).
Installation
INSTALLATION
1. Position the folding top header latch switch (3) onto the presenter plate (5). Insert the switch mounting tab into the slot on the presenter plate (4).
Pivot the switch (3) downward so that it is sitting flush on the presenter plate (5) and the switch position sensing tab is next to pivot on the latching
rod assembly.
2. Install the switch retaining rivet (2).
3. Connect the switch electrical connector (1).
4. Observing the location marks made during removal, position the folding top presenter plate assembly (3) onto the bottom side of the windshield
header (1).
5. Install the presenter plate retaining bolts (2) finger tight.
6. Connect the presenter plate electrical connector located on the right A-pillar.
7. Connect the battery negative cable.
8. Close the folding top completely so that the header latches are fully latched.
9. Tighten the presenter plate retaining bolts (2) to 10 Nm (88 in. lbs.).
10. Cycle folding top open then closed to ensure proper presenter plate alignment.
11. Disconnect the battery negative cable.