Sebring Sedan L4-2.4L VIN J (2004)
4. Install nut attaching top of rear guide bar to inner door panel.
5. Verify glass fit and operation. Adjust door glass as necessary.
6. Install door trim panel and watershield.
Front Door Inner Belt Weatherstrip
FRONT DOOR INNER BELT WEATHERSTRIP
REMOVAL
1. Remove front door trim panel.
2. Pull upward at rear end of inner belt weatherstrip.
Fig. 9
3. Remove inner belt weatherstrip from vehicle (Fig. 9).
INSTALLATION
1. Place inner belt weatherstrip into position.
2. Start weatherstrip at the front and rear edge door. Press downward on the inner belt weatherstrip till it is fully seated.
3. Install front door trim panel.
Front Door Outer Belt Molding
FRONT DOOR OUTER BELT MOLDING
REMOVAL
Fig. 10
1. Remove screw attaching rearward end of molding to front door (Fig. 10).