Sebring Sedan L4-2.4L VIN J (2004)
Fig. 11
2. Using a rubber mallet and block of wood, tap upward at each clip attaching belt molding to door (Fig. 11).
3. Lift up on the rear of the belt molding and pull rearward to remove.
INSTALLATION
1. Place belt molding in position.
2. Using your hand press downward at each clip attaching belt molding to door till in position.
3. Install screw attaching rearward end of molding to front door.
Front Door Glass Run Weatherstrip
FRONT DOOR GLASS RUN WEATHERSTRIP
REMOVAL
1. Remove door glass.
2. Remove bolt attaching bottom of front lower run channel to inner door panel.
3. Pull glass run weatherstrip from door glass opening frame.
Fig. 8
4. Remove lower run channel through opening at top of door (Fig. 8).